2017–2019 Audi RS3 8V Sedan Rear Bumper Lip – Forged Carbon Fiber

2017–2019 Audi RS3 8V Sedan Rear Bumper Lip – Forged Carbon Fiber

Add a wider, more planted rear presence to your Audi RS3 8V Sedan with this forged carbon fiber rear bumper lip. Purpose-engineered for the factory rear bumper, it sits flush against the lower rear bodywork to extend and sharpen the rear profile, with the distinctive marbled forged carbon finish setting it apart from conventional woven carbon parts.

Build

• Material: Forged carbon fiber, produced from compression-moulded chopped carbon fiber rather than a woven sheet — giving each panel a unique marbled, flowing chip pattern with no two pieces identical
• Manufacturing: 3D design and CNC moulding with full autoclave curing for precise panel geometry, consistent surface quality, and high structural integrity
• Surface finish: Polished and UV-protected finish that holds its deep gloss appearance through sustained outdoor and driving exposure without fading or yellowing
• Configuration: Single-piece lip for the lower rear bumper
• Weight: Lightweight at approximately 1.76 kg

Design & Finish

• Distinctive forged pattern: The marbled chip texture reads very differently to traditional twill weave — a bolder, more contemporary look associated with high-end supercar trim
• Aggressive stance: Lip profile extends and sharpens the lower rear body for a more planted, track-inspired visual stance
• Broad coverage: Spans a wider section of the lower rear body than a standard diffuser lip for a more complete finish
• Factory-style integration: Purpose-engineered for a flush fit against the factory rear bumper

Fitment

• 2017–2019 Audi RS3 8V Sedan (2.5 Quattro)
• Fits the RS3 8V factory rear bumper only — not compatible with aftermarket or non-RS3 bumper configurations
• Not compatible with the standard A3 or S3 rear bumper, or with the later 8Y generation RS3
• Body style: Sedan only — not confirmed for Sportback variants

Package Contents

• 1 × forged carbon fiber rear bumper lip
• Adhesive tape for installation
• Mounting screws for installation

Installation

• Two mounting options: Fit with the included adhesive tape for a reversible install, or with the included screws for a more permanent, secure fitment
• Surface prep: If using adhesive tape, thoroughly clean, degrease, and dry the rear bumper before fitting to ensure maximum adhesion
• Alignment: Dry-fit and check the lip sits centred and even across the bumper before committing to either method
• Professional installation recommended for correct positioning, panel alignment, and a clean finish — particularly if using the screw-mount option

Before You Install

• Confirm your car is an RS3 8V Sedan (2017–2019) before ordering — this will not fit the A3, S3, or the later 8Y RS3
• Forged carbon patterning varies between pieces — the marbled chip effect is unique to each panel, so your item will not match product photography exactly
• Screw mounting is permanent — it requires drilling into the bumper, so decide on your method and confirm placement before starting
• Work in moderate temperatures and allow the adhesive to cure fully before washing the car